Starting of 4 stroke engine:

1.After all installation finish, fasten all the screws;

2.Add the fuel (check whether the oil pipe is connected in good condition;

3. If all fine, press the oil bubbles inside the carburetor, to empty the air;

4.After full fill the oil,lock the throttle, then switch on the ventilation door, pull the starter, in about 3-4 times, when hear the detonation sound, press off the ventilation door, then pull the starter, the engine will be started in about 2-3 times.

5.Add engine oil in the engine oil tank to the bottom level where the oil level gauge can touch, but do not over the level 1. Add the petrol to the petrol tank.



Starting of 2 stroke engine:

1.After all installation finish, fasten all the screws;

2.Add the fuel (check whether the oil pipe is connected in good condition;

3.If all fine, press the oil bubbles inside the carburetor, to empty the air;

4.After full fill the oil,lock the throttle, then switch on the ventilation door, pull the starter, in about 3-4 times, when hear the detonation sound, press off the ventilation door, then pull the starter, the engine will be started in about 2-3 times.

5.About the fuel, the 2 stroke engine use gasoline fuel (mix of petrol : 2 stroke engine oil = 25:1)